Fireball Modelworks 1/25 Scale Figurine STL Files
FMR-518-STL Stumpy
All my figurine models are 1/25 scale in millimeters
There are tons of resources for getting good results resin-printing miniature figurines.
To ensure a successful print, here is what I do:
- hollow the model in your slicer of choice. 0.75mm walls work well.
- add drain holes in strategic locations. I use 1mm drain holes normally, and position them so that there is no suction-cupping at the beginning of the print. I also make sure to add drain holes close to the highest points of the model
- depending on the details of the particular model, I normally print them standing on their head and slightly tilted back so that their front surfaces are as free from supports as possible.
- for supports, I use thin ones and lots of them.
These figurines can be rescaled within reason. They can easily go up to 1/18 scale for use with die-cast cars and they can go down to 1/35 for military models. I would not try to go larger or smaller than those extremes.
